D
Dewg
Active Member From Southern California
Latest activity Postings About
-
-
DDewg replied to the thread FSD v12.x (end to end AI).Thanks for clarifying - it seemed you were making a statement that FSDS would typically just run into the cutting car/truck without...
-
DThat’s what I mean by typical. I didn’t mean to imply just charging at a truck with no sign of stopping was typical. Usually...
-
DDewg replied to the thread FSD v12.x (end to end AI).Woah, "completely typical" is a bold statement. Again, I've never experienced this, as my car brakes when cars/trucks have cut out in...
-
DDewg replied to the thread FSD v12.x (end to end AI).It's hard to tell from video, but my experience would have been the car starting to brake fairly hard, around 7-8 seconds in your video...
-
DYes. That was my expectation but it did not happen here, and it was given time to respond before I made my request. It’s not like I...
-
DDewg replied to the thread FSD v12.x (end to end AI).So far, in my experience, whenever a car or truck "cuts" out in front of me, FSDS has braked, usually pretty hard, for them. I have...
-
DYeah that was my bet, and I would have done that too. Unfortunately that is not what happened. It was kind of surprising! So had to...
-
DDewg replied to the thread FSD v12.x (end to end AI).In your case, disengaging was the correct procedure, and I would have as well in your situation.
-
DDewg replied to the thread FSD v12.x (end to end AI).I personally would have just let it go. The truck came out, and my bet would be that FSDS would have slowed down to let the truck...
-
DWow, doesn't look like his chart matches this one. I added your chart to the post chain. Thanks
-
DNot stepping out when there is no traffic around was a regular occurrence in Omar's 12.3.6 videos. There's no doubt in my mind that the...
-
DDewg replied to the thread FSD v12.x (end to end AI).You mean this FSDTracker? (teslafsdtracker.com)
-
-
DDewg replied to the thread FSD v12.x (end to end AI).And his experience with stop signs is the exact same that I have, which is perplexing when I read people who say it sits there for 10...
-
DDewg replied to the thread FSD v12.x (end to end AI).Looks like it's still stopping behind the line - not much change there. Stop signs looked good. Turns looked pretty good - though it...
-
DDewg replied to the thread FSD v12.x (end to end AI).I thought about this recently, and I'm curious if this blow-back against AVs and ADAS systems, like FSDS, are a temporary problem. It...
-
-
Loading…
-
Loading…
