Recent content by mitchellh3

Nevermind I just found this: Gen 3 Wall Charger - Power Sharing Looks like its not supported yet so I'll just set em to lower power outputs for now.

Hello! I’ve installed two gen 3 wall connectors on a shared 50A circuit. My wife and I don’t drive too much so the 50A should be totally fine. I have them both configured. But I can’t tell how to configure them for power sharing? The installation guide says this is coming in a “future update”...

I bought the FSD upgrade at $3K for my 2017 AP2 car. Southern California. Anyone have any idea of typical wait for backordered FSD computer and when Tesla will reach out?

Hi, I can't find any clear information on this... can I do power sharing (or load sharing) between a gen2 and gen3 wall connector? Or should I purchase a 2nd gen2 model instead?

Does anyone have any idea what the expected ground clearance of the roadster is? I want to reserve one and I'd probably send my wire for a founders edition tomorrow if I knew the answer to this. I have a driveway where even with the Model S (~5" clearance) I scrape the bottom every time I...

Yeah. I dunno its not that crazy... I'll try to get a picture. When I enter/leave at an angle its fine. It touches but barely and it doesn't worry me at all. Its just kind of a PITA to do that every time (its not natural with this driveway since its kind of thin) so I'd rather just scrape it up...

Great to hear. Yeah, I figure my concrete driveway is never (for a reasonable definition given a car) going to break down the metal rails. I'll be asking my service center soon though.

Just moved into a new home. I have a relatively steep downward facing driveway. At the top, my Model S bottoms out and it scrapes a bit. Will this cause damage to my car? The car bottoms out right in the middle/center of the car, not the front or back. I can't use a curb ramp because that's...

My hope is that the no-stalk introduction means that they also made significant improvements to NOA in general since the last release. We haven't seen a 2019 build yet so presumably there is going to be quite a lot of change in the underlying firmware since we'll be seeing roughly ~10 to ~15...

I think it just hasn't happened yet. I'm on 32.2 as well. Actually my biggest question is why those of us on 32.2 never got the PIN-to-drive update. Haha.

I still haven't received the update either. 32.2 over here. According to Teslafi if their sample size is large enough we're maybe at a 20% fleet rollout. Hopefully we get it soon. :(

My AP2 car has been connected to wifi all night/day and I'm still on 32.2 :( Teslafi isn't showing much movement on AP2 32.2 cars... getting antsy. I wonder if I should call and ask.

I'm an AP2 person but it appears no cars EXCEPT AP2.5 cars are getting the update currently. :(

As far as I know, AP2 cars are not getting V9 yet. I mean, it still might happen today sometime, but it hasn't started yet.

... except if you own an AP2 car currently. *cries* From Introducing Software Version 9.0