Recent content by rvandrew

@chojn1 Is there an update?

@chojn1 , any update on this project? Thanks

@chojn1 Just a check to see if there is any new news

@viktorleon , Have you had any success with the files for the rest of the Tesla T's, (front, back, wheels, steering wheel, or turn signal bulges)? Thank you

Any update? Looking forward.

Any news ?

Looks great. Have you determined that a slit to allow slight compression is not needed?

Since this looks like it may be on hold for the foreseeable future, would you consider sharing the 3D models of the brackets and shroud? I have access to a 3D printer with carbon fiber capabilities and would love to give this a try. Additionally, I can see the mount for the light in the...

@chojn1 , any update?

Just checking on status?

Sounds good, thanks for the update @chojn1.

I hesitate going over to the existing thread you mentioned. As far as I can tell, 38 page forum, and the majority of the conversation has to do with when one vinyl kit or another will be available on Amazon. :). OK, that is a major exaggeration, @Kenriko and @AMIYY4YOU have been doing a lot...

That sounds like a good plan. The basic designs for window and door switches as well as console patterns are in a github location, but I know there have been some improvements made. I am tied up for a couple of days, but by the end of the weekend I will put together what I have and find a spot...

I found a Tesla T PDF online, downloaded Inkscape for free, the learning curve for the Cricut was relatively easy. I just tinkered with different sizes, cutting the parts out of cardstock while I figured out what size would work with which location. I ended up doing a little hand cutting on...

I did end up buying a used Cricut just to play with the vinyl. I did the switches and area around the switches in a textured black called cocoon, did the door switch in brushed red. Also did the center "T" on my wheels, the "T" on the side camera mounts, and the front and back Tesla T on the...