Search results

Thank you for your feedback, but I believe most users on this board probably aren’t “average”. You’re right..4 or 5 minutes don’t really matter, but I do enjoy learning about how the system works, tweaking it, and comparing my experiences with others on here. If you do a search on here, there...

Yes, I can shutoff the grid breaker and production seems nice and smooth. It ramps back up very quickly (in a few seconds) and starts charging the PW2s. On some of the other profiles I tried, production was bouncing all over the place.

One more thing, when reviewing the Grid reports, I noticed for the Louisiana one that this was set to "Yes". I haven't seen that in any of the other profiles I've looked at. "Loss of phase detection enabled Yes"

Thanks for the response. Yes, I'm monitoring the frequency while off grid. When the PW2s are at 100%, or in the 90s, my frequency is at 62.5, then it slowly tapers down after that. I went thru the logs today, and noticed on the days when I switched to the Louisiana profile (and was still...

Thanks for the reply. With the grid connected. The only way I can get the Microinverters to start producing again is to change the profile and then wait until the next day.

What's the recommendation these days for a grid profile with a quick restart (less than the 5 mins of the IEEE 1547 default profile) for use with the IQ8 microinverters and the Powerwalls? I'm using USVI-IQ PW2 right now as it has a 10 sec reconnect time and it seems to be ok, but is there...

Hi, I recently had two powerwalls installed, and everything was working fine until a few days ago when the utility company cut power to replace my meter. Ever since then, my Powerwalls have been stuck at 21% charge and won’t charge/discharge, so all my solar power is just going to the grid...