Hi gregd,
Thanks for the replied. Are you talking about the wiring diagram shown below?
I am planning to rebuild the wire similar to what you've have done, but I am planning to do it differently. As the motor is 10 years old now, I am planning to buy a new one (image attached). I am planning to bypass the AMP connectors at the fan side (which are problematic). Simply cut it and directly connecting the two fan power cables (one positive and one negative) to the four power cables coming from the PEM fan socket. I am planning to get a new molex female connector (19418000). Then hook up 4 new cables to it. These four cables will run all the way to reach the motor for direct connection.
To avoid mis-understanding, please help to confirm whether the following connection is correct:
Connect the wires from
Pin1 (motor fan +) and
Pin2. (pem fan +)
together with the
positive wire come out from the fan (twist 3 cables together, wrap with electrical tape, then properly placed)
Connect the wires from
Pin3. (motor fan -) and
Pin4. (pem fan -)
together with the
negative wire come out from the fan (twist 3 cables together, wrap with electrical tape, then properly placed)
I am planning to skip the PowerPole connection that you've done.
View attachment 612482
View attachment 612481