Recent content by Ferjy_Fangle

My 2021 MYLR has USS.

Power Off from the Safety Screen got rid of this for me. Went back to no update after that.

Anyone seen or had any experience with this? (Says ships in late October) https://ev-lectron.com/collections/ev-adapters/products/lectron-ccs1-adapter-for-tesla-fast-charge-your-tesla-with-ccs-chargers-black

I though about this, but if you look at the lower left of the left port it looks a least to me that a piece of metal was jammed in to make it difficult to remove. Could have been melted, but it looked jammed in and the plastic piece was skewed to the upper right.

Was there 6/25/2022 and one of the chargers "5B" looked like it was intentionally vandalized (see attachments) and would not charge. Was able to charge on "5A" and checked all the other plugs not being used for charging and they looked OK. Called Tesla to report and they said site was offline.

For me it was the Proximity Detection which involves the latch lever on the charging cables. Make sure you open and close it a few times when attaching your J1772 adapter to the charger plug. Also, make sure the latch is pushed all the way down on the adapter. This has worked for me and I have...

For me it was the Proximity Detection which involves the latch lever on the charging cables. Make sure you open and close it a few times when attaching your J1772 adapter to the charger plug. Also, make sure the latch is pushed all the way down on the adapter. This has worked for me and I...

Just loaded software 2022.16.2 on 06/24/22. 2022.16.1.1 and 2022.16.1.2 have been working since 06/08/2022 with no "Dashcam RED X Error of Death". Go figure? Have been using a SanDisk 256GB MAX Endurance microSDXC Card with a Kingston MobileLite Plus USB 3.2 microSDHC/SDXC UHS-II Card Reader.

Just loaded software 2022.16.1.2 on 06/22/22. 2022.16.1.1 had been working since 06/08/2022 with no "Dashcam RED X Error of Death". Go figure? Have been using a SanDisk 256GB MAX Endurance microSDXC Card with a Kingston MobileLite Plus USB 3.2 microSDHC/SDXC UHS-II Card Reader.

Still working for me. Have had no failures since loading software 2022.16.1.1 on 06/08. I guess I just jinxed myself though! LOL

FYI - Tesla removed the requirement for 12V disconnect on the Model 3 for ECU remove and replace the week ending June 4th.

For those who have used the "Service Mode - Software Reinstall" route to update to the proper firmware after the ECU swap does the Software have to be downloaded again through WiFi or is it already stored for reinstall?

Just loaded it ... will see, but I have little hope.

Good luck with that!

Not saying disconnecting 12V power is necessary for the Model 3, just that Tesla recommends it according to their Service Manuals. However, they do not for the Model Y's. They also recommend to "Connect a 12V support charger to make sure power is not lost during the update." when doing the...