Recent content by hydroskillet

it's 80K for dual motor, not 90k, but still outside where I'm going to buy now.

Maybe I missed this, but where's the FSD? Like it's not even an option on the site, and I thought pre-orders were locked in at whatever this cost me when I added it after launch event.

It was a good idea on both counts. Sharing was disabled. Tried 20 amps but it looks like it it still wants to go at 60. Here's a couple screenshots of me setting the amps and then the home screen that just spins. Nothing loads unless I do /sharing, /installation, /service, etc. If there's a...

I manually updated firmware with most recent version. Is it possible to download legacy firmware and update? ..... with the backplate it's basically the same as 4 posts down on this thread. NEMA 14-50 HPWC

Actually I didn't, but I did reboot it and it said the same..... mine has all the lights illumiated going down like it did 3 years ago when it worked. I'd thiink it would be 5 amps after setting this to the 50 amp breaker settings at 192.168.92.1/installation. it's an outlet wired about 3 feet...

so you think it's a wiring issue and I don't need to go through warranty to get a new wall connector? \ Understand it's non-standard and thanks for the feedback. I'll have it wired to the breaker.

Thanks all.... That's my biggest question. The thought with the charger was to use it at a beachhouse as well, but if it needs to be hard-wired, that's fine too. Regardless, I was trying to see if something was wrong with the wall connector.

Sure thing. Here's the basic setup w/ volt readings off the wall. The cord is rated at 50 amps, but I assumed this was a common practice based on other posts here. Also, in the wall connector, I set for a 50 amp breaker not 60. I assumed this was supported, but if it's not I'll have a new line run.

Sorry, it's jusst a 14 50 wall connector. Is it not supported to use a 14 50 wall connector with Tesla Wall Connector Gen 3? Reading the forums it seems like many use this with 50 amps. I haven't modified anything.

So rather than run a conduit and hard wire a line, the electrician installed at 14 50 outlet from a 50 amp breaker. The cable used to the wall connector is a NEMA 14 50 / 50 amp rated cable. The wifi was something that just started not working right the same time this issue happened, but...

Has anyone seen an issue where you can only get a charge from the wall connector at 6 amps at 240v? Of note my travel charger gets 12 amps at 110v. A bit of backstory, I purchased this in 2020, used it for a month before I sold my house (so maybe 8 times max).... Then the new house needed a...

Had exact same issue last night / this morning. This just auto-magically updated to FSD and I could suddenly enable. This is multiple reboots and several drives later. I parked for 4 hours, came back out and it was there. edit: I did have a Snickers... this was probably the fix.

Just auto-magically updated to FSD and I could suddenly enable. This is multiple reboots and several drives later. I parked for 4 hours, came back out and it was there.

Definitely not TPMS and drove last night and this morning with no changes unfortunately. Also did reboot and reboot with break and didn't seem to fix.

Just like the title says, installed FSD 10.4 beta last night with 2021.36.8.5, but no FSD. Looking in autopilot settings there are no options to enable it.