Recent content by S2000

I believed all new Tesla 3 and Y are using the new AMD Ryzen CPU now...

Is it make by Hansshow?

These guys did a terrible job on my 3 and refused to make it right. There are still dust bubbles everywhere on all the windows. I would never recommend them to anyone...

Those strong struts bent my hood upward so I took them off...

I am using Prime Line SP-9609 spring with stock struts and it haven't fail me yet...

I got dust bubbles on most windows especially the windshield and back. They had to redo most of the windows but it actually look worse the second time around. They blamed it on Tesla's windows and the 3M Crystalline film being difficult to work on...

Just avoid Rodz Tint Shop in Fountain Valley. They did a terrible job on my 3. :(

So final pricing is $450 OTD for the trunk with foot sensor?

Depending on final pricing. I may be in for this. Thanks OP!

Seal inward above... Seal outward. I like the outward look better...

Mine also move around a little bit on the 2 front flaps. However, I put a small strip of 3M double sided tape near the top between the flap and the body panel and it's pretty secured now. Give it a try...

I did this too. I think it looks better with the flange out and over the bumper. Not sure if this is the correct way though...

This design maybe better? Front Rear Mud Flaps For Tesla Model 3 2016~2019 Splash Guards Mudguards | eBay

I added a little 3M double sided tape at the top of the front flaps in addition to the screws and it seems to keep it from moving around without the tape. There's a little bit of a gap on both sides at the top of the flaps though...

Where did you get the U-nuts and which one that fits? Thanks!