Search results

Had a tire in my back seat for a few weeks it was covered in plastic so thought nothing of it. But it left a few brown grooves on my white seat from dirt on the thread. Any ideas for this sort of stain? I tried normal cleaners.

Needs more if statements IF car <bumpersticker = "You're following too close -or "*insert other dumb bumpersticker*" { Set acceleration = Max Set breaking = Off Play murica f ya theme song after rear end = true }

Will try it out tomorrow morning on my commute and see! Hopefully it's something I can check within the month before trial expires to see if they actually take note.

So actually big realization today when at tesla (somehow after 3 other visits for wind noise they didn't see this). But I guess whoever wrapped my car ( I got it used with 19k miles already wrapped). Forgot to put the seals back on the doors. All 4 of my doors are missing this seal. Anyone think...

Not that I can find when on the route, It's such a small adjustment I don't think it recognizes it as a full on different route unfortunately. This happens about 2 minutes from work so i'm basically almost at my location it doesn't give me other routes that I see once on that point when pressing...

Unfortunately FSD is useless now for the final part of my commute to work I found out today after trying the newest version for on the way back to work (it did this on v11 as well so not version specific). Since it follows guidance and you can't modify the path it takes, There is a route it...

https://share.icloud.com/photos/02f9gjq5VcFP1SL2JEPgVNNNw Took my bro for a test drive with the new fsd, pretty impressive so far after 300 miles. Other than the changing lanes in NJ since I’m near NYC right across the water in Secaucus. Putting your blinker on basically tells other drivers to...

My post is in regards to driving on highway not auto park

I ended up rebooting after that the update had “connect to wifi to start” again at 100% after that I connected it and it finished within 2 minutes. Not sure why

Issue is the blinker doesn’t stay on. If it did that’d be a benefit. But it just turns it on, tries to see if it can move over. Then turns it off, then like 10 seconds it tries again, if there is traffic this is basically non stop. I’ve only tried the version today about 100 miles so might be a...

Damn so this fsd version doesn’t include the enhanced auto park? Or am I just doing something wrong. Doesn’t seem like the videos I’ve seen where it highlights spots

How have they not fixed lane changes yet. The car turns on the blinker when there is a car in the right lane slightly behind you then turns it off and tries over and over. In NJ nobody lets you in cus of a blinker. Way too passive of a driving type, I have to turn minimal lane changes on every...

My 2024.3.10 been stuck at 100% downloaded for an hour now :(. Hoping it gets unstuck soon, never had this happen on an update usually 100% is like 5 minutes. I’m on the last update as well not multiple behind.

just got a prompt to install 2024.3.10 should this have the fsd trial or should I hold off?

Tesla did recently replace my whole body seal since my original had a similar divot and I played with it too much probably making it worse they also tightened the glass. My window seems to stick out farther than the b pillar though, I noticed in your video your window seems to "sink" under the b...

Ordered some hacksaw blades so will see - the gap really only seems near where the window seal curves near the b pillar so i'll probably put 5-6 inches of it near there on the metal to push it out and see, the seal has a tiny divot in which seems to cause it to not touch the window as tight. I...

Tesla tightened the door and windows, though the door still goes slightly over the passenger door so I think I can tighten it a little bit more. I may try shimming first then go for that. Any advice on anything other than the hacksaw blade you suggested in your video for shimming?

Kind of made it worse at the top (the side helped a bit I did this a few weeks ago), The issue seems that it caused a whistle I guess since some area's not touching the glass fully? That area might be better to shim possibly. Not sure why adding caused it to whistle, once I took it off it went...

I just put some on will see how it goes - The window seems to push up the rubber when it goes up so not sure how long it'll last I may need to extra adhesive it, but after adding it my cardboard card won't even go up at that part so that's good - Will see results and post here

Did you use this for the top part of the window too or just the side near the b pillar? Was deciding between this for the top or the shimming process george mentioned.

What type of weather seal are you using there? Hard to tell from the photos

Hi All, I've been dealing with wind noise from the corner of my front driver window near the b pillar by my ears not making contact, I've had tesla replace the full body seal, adjust the door, adjust the window and still it sounds like the window is basically open driving 20-80mph, I put a D...

anyone got advice on how to get aftermarket weather stripping to stick to the rubber? I've tried cleaning it with alcohol then applying adhesive promoter after it dries then applying the seal after about 3 minutes of the adhesive promoter and the 2 seals I bought will barley stick to the rubber...

That’s good to hear, my hum is probably enhanced due to my window corner not making direct contact so the window sounds somewhat open in the corner. So once I can figure that out I think the hum will be much less noticeable

Anyone have a suggestion of a very thin D seal or B seal for the window my gap is like 0.1 inches down the side of the window. I also can’t seam to get 3M to stick to the rubber even with adhesive remover anyone have this issue?

Sadly didn’t fix the issue for me, the corner where there is blank space hangs which when the door is closed causes it to not contact for me so my corner window wind noise is still there. Going to try putting something behind it to maybe lift it and hold it in place

I still have a slight hum, my initial hum was also accompanied by a rolling over a rock type feeling. I think these just have a hum sound in general. After 1-2k miles I deff think they’re louder than the stock tires. Hoping they at least last more miles

maybe it was an illusion from the photo, but mine dips down into the bpillar similar to this pic that someone else posted. Where as I am pretty sure the seal is suppose to be inserted into this slot here?

Do you leave your seal pulled out over the b pillar? I noticed mine is tucked in but looks like it's not inside the small slot the bpillar has for the edge of the trim, I think this is causing my issue. I tried reseating the seal into the small slot it has, curious if you just pulled it over the...

Got the 2 in rear swapped out that was where the 1 defective tire was. Shop got the new ones road forced for 8 pounds and 9 pounds since they match mounted compared to 13 and 15 on the old ones. Paid $390 after install + mount and road force with hazard warranty. Going to return the 2 in rear...

Had the tires rotated and the bounce went to the rear so the steering wheel feels perfect so I guess a bad tire, having the 2 now in the rear swapped out by ETD and the other shop said I can return the 2 for a refund since we can't determine which 2. The 2 in the rear now oddly enough are 10 /...

Yeah i'm curious - the rear tires were 8 pounds and 11 while the front were both 13/15 so do you think having them rotate front to back may make it less noticeable? I think this may also help confirm if it is the tires, it is winter here and like 28 degrees F some days so I'm sure winter isn't...

Tires were all off according to ETD feels way better now albeit still a slight bumping feeling that seems from right tire apparently the road force was 23 pounds before they got it down to 15.

It was across the street from me i've been for a few years and I explained the situation to him - he said 30 bucks out the door since i'm basically a neighbor. He didn't have appointments till next week though so I ended up going to ETD tires that has a road force elite and is doing it for $80...

Called ETD tire since they have the road force elite and the guy asks what brand I tell him Sailun and he goes "Sailun that's considered like bottom of the barrel brand for tires usually i'm suprised people are putting them on teslas. Not to knock you or anything, I haven't seen that before so...

Going to a road force balancing place Thursday, I noticed the 2 front tires have red dots on them from manufacture and they're not near the valve stem or opposite which I believe they're suppose to be. Hopefully the place Thursday can fix it - they have 5 stars with hundreds of reviews vs pep...

235/40/19 Sailun E ranges, I got them rebalanced free at pepboys. The same issue is happening maybe slightly less bad but I don't really trust them since it doesn't even look like they touched the weights. It's hard to explain it almost feels like one of the tires is hitting the tiniest bump...

Steering wheel seems to shake a little at that speed - I tried testing wheel bearing by veering left and right and sound stays the same. Also the sound changes over different pavement which I read indicates something with tire. Going to have them re-check tires balance / alignment and see if...

Got these Sailun's today and I now notice a humming sound at higher speeds, Not sure if it's break in period or maybe bad balancing by the techs. I got these + alignment and the hum is so loud at 60-80mph. Going to see tech again to make sure they balanced them right. I see online people say it...

Got these Sailun's today and I now notice a humming sound at higher speeds, Not sure if it's break in period or maybe bad balancing by the techs. I got these + alignment and the hum is so loud at 60-80mph. Going to see tech again to make sure they balanced them right. I see online people say it...

This is where I mean, leading up to the top of the windshield

Anyone know of anything that would fill in the large gaps in the front windshield? Seems like each side has a small gap between the glass and the body I wanted to try and maybe fill it in with rubber or weather stripping to see if it makes a difference

Do you have a link to the block of foam you used that was shoved in the front door area by the z seal? I saw mention of a big block of foam that was squeezed in. Or did you just stack a few layers of this and squeeze it in there?

Does anyone have a link to the foam block used in the first post that fills the triangle? Also I noticed OP has a small rectangle of foam stuck on the door is that the same foam? The really tiny piece that looks like it seals the door.

Been a few days since pretensor was replaced no errors since I think without warranty it would been about $200 repair.

Had this starting a few days ago - Today tesla came and replaced the Pretensor free of charge (I'm under Used warranty). Took about 15 minutes, Going to pray the error doesn't come back. I have warranty for another 12k miles so not too worried. 2019 Tesla Model 3 here

The link in my post isn't a referral link - I removed it a few minutes after submission

This is behind the rubber btw, If you peel it off there is some sort of small hole - The way I did it prior was glueing the rubber to the front under the flap that the window barley touches.

That's what I did as well I superglued a piece of rubber under the flap to lift it up more to tighten it, The tech saw this and laughed and suggested this as a better solution as mine was causing the window to bulge out more due to it and he thought it was doing more harm than good, He said...

It basically lifted up the edge of that piece that seals the window from behind so it looks like the rubber is touching the window a lot more. I haven't gotten a driving test in but I used Gummi Pfledge on the rubber and since it's wet I can see the seal really well and it looks like the rubber...