You can install our site as a web app on your iOS device by utilizing the Add to Home Screen feature in Safari. Please see this thread for more details on this.
Note: This feature may not be available in some browsers.
Hi all - did any of you ever get to bottom of these strange errors? I recently paid for FSD upgrade and updated MCU and got the AP3 HW upgrade done. Was flawless for first three weeks and then this week after latest .30 firmware update getting the dreaded camera errors:
- re-ran calibration of cameras which seemed to work for few minutes
- washed car so everything clean
- suspect pillar camera on passenger side as it isn’t appearing when activating camera mode
- tired reseting car computer couple times to no avail
it is cooler here -4C and this happened at night.
anything I should try? I am out of warranty but given I just paid for all these upgrades (8K+) I am hoping the service visit would be covered.
I believe I had it wrong - it appears to be the two side fender cams are missing - not the pillar came.
One failed and then the other one went offline within a couple hours. So very bizarre! Maybe car wash related?
do both cameras plug separately into MCU or do they first connect to common harness somewhere?
Out of warranty but since I recently had MCU and AP upgraded (early Dec) I will push them to check the connections before replacing cameras. Cameras worked for 3 years without issue before the AP/MCU upgrade.
Have a hard time believing both cameras would fail within hours - even if car wash related. Seems like connection, wiring loose or firmware?
In meantime, I don’t even have cruise control