Hi Everyone
I’m driving the struggle bus today, and need some help.
Situation: Condo garage, i have two Gen3 wall connectors attached to the same sub panel, serving parking spots that are about 200-250 feet apart, and unfortunately are not within line of sight. We have wifi covering the entire garage, both cars and both wall connectors are on the same wifi network.
I want to enable power sharing, but when I try to add either WC, I get the following error: This device has already been added to the network (See below).
im guessing that power sharing needs to set up an adhoc network for communications between the 2 wall connectors? If so, then why are there all the references to home wifi?
Or am I missing something basic?
thanks!
I’m driving the struggle bus today, and need some help.
Situation: Condo garage, i have two Gen3 wall connectors attached to the same sub panel, serving parking spots that are about 200-250 feet apart, and unfortunately are not within line of sight. We have wifi covering the entire garage, both cars and both wall connectors are on the same wifi network.
I want to enable power sharing, but when I try to add either WC, I get the following error: This device has already been added to the network (See below).
im guessing that power sharing needs to set up an adhoc network for communications between the 2 wall connectors? If so, then why are there all the references to home wifi?
Or am I missing something basic?
thanks!