Recent content by MY-Y

I replaced my OEM tires at 22k miles (with 4/32" tread). My taller (255/50r19) quatrac pro tires have 46k miles so far and still have enough tread to make it to next winter.

I'm on 2023.44.30.25, which has FSD 12.3. It is way better than any other version I've had since I got FSD in 2020. It handles toll booths, traffic circles, etc. It did scrape a curb in the first 500 feet I drove with it. Fortunately, it was a rounded asphalt one, so no wheel damage. I'll...

I guess it depends on what you're used to. My F450 truck has the tight turning circle of 50.4', which is one of the reasons I got it. The similar F350 has a turning circle of 59.6'. Those 9 feet are very noticeable when maneuvering a trailer. Not surprisingly, my MY feels quite nimble to me.

Here is some data to further the conversation. I did a quick test with Scanmytesla this morning. Quick summary: Medium Fan speed is best. Probably should just use "auto." Theory: Air is made hotter at low fan speeds to meet temp setpoint, so setting the fan too low is inefficient. I tested...

I had issues with my 2020 spray nozzles until I learned that they can be aimed. Simply put a needle in the hole and use the leverage to move the nozzle to spray in front of the wiper. They are designed to be adjusted this way. I had to fiddle with the aim position to get good performance, but it...

As the OP, I can tell you that I've got over 38K miles on mine with no issues.

I've experienced that weird subsonic unhappy feeling when not moving when my vents were blowing across my screen in just the wrong way. Maybe this is your issue. Just adjust the vents to see. For me, there is a narrow range of fan speed and vent direction that causes this.

If you spill something that soaks the trunk bucket liner, you need to remove the liner and clean under the hard foam board beneath it. Otherwise you still have the liquid trapped down there. I used dish soap, and a hose to thoroughly wash liner after removing it (the water runs through it) and a...

If you want to know how they align, just put soapy water on the rubber stop and observe the water circle when you open. (Soap is needed to stop the water from beading on the hydrophobic rubber stopper.)

Both subsonic and ~40hz are addressed by eliminating excessive hatch movement.

Yes. It just slips inside the valve stem and the slot engages the core. You just snug it down - not too much torque. Please report back to the group on your results.

In a hangar, your choices may be 208/120 if it has 3-phase power.

Valve core is loose, broken, or has dirt in it. Step 1. Push the pin in to expel some air and see if the leak goes away. Step 2. Get a valve stem tool (auto or bike store and tighten core. Step 3. Replace core.

I use a GPS app on my phone to determine the speedometer accuracy. I use the Scanmytesla app with an OBD-II Bluetooth dongle spliced in my cable behind the arm rest to measure my 0-60.

Aaah. The speedo related to the 0-60 time... From 1.5% high to 1.5% low =~3% difference. My scanmytesla records 0-60 using the speed the car thinks it's going. With AB, my 0-60 on OEM tires reports ~4.2 seconds. This was really 0-59. With the taller tires, it reports ~4.7 seconds. That's really...