Search results

If you scratch the tow hitch cover no big deal. Can get replacements for around $12-14 USD on aliexpress.

The front bumper now with vehicles with no ultra sonic sensors is so much easier then with the sensors. Done about 6 bumpers now as DIY for myself and friends and ya I can do it in less than 2 hours now.

I have 7 seater LR Y and installed 5/16 OD tubing and it closed ok.

Picked up the new trunk seal here in Canada today, and purchased 2 of Vinyl Hose, 5/16-in ID x 10-ft from Canadian Tire Easy to push through when the trunk seal isn't installed. Pulled off the old seal with all it's sticky glue, and installed the new seal with the tubing installed...

Not bad here in Canada $22 plus tax for the trunk seal part. Gonna get it and get some tubing and see if it makes a difference

Go into service mode and try reinstalling your software. I did that a few times, not sure if it helped, but it eventually turned back green.

It just magically worked again. I even bought a used driver side mirror assembly on eBay, but didn't even need to swap..

They use a AT&T sim card or E-sim, that roams and hops on different providers in Canada/USA.

Bring it it to the body shop.

I personally wouldn't put the module there as it's on top of the crush cans. Perhaps mount it with the VHB tape where it's supposed to be without the mount is better.

1107677-00-A - HVAC, PTC SERVICE ASSY, M3 (the new cover) part after cutting out.

The tesla service manual instructions to remove and replace the amplifier isn't too bad. That, plus you can buy the amplifier part used from ebay or from TESLA MODEL 3 AUDIO,AMPLIFIER,EXTERNAL 1079748-00-C here in Quebec and have it shipped isn't too bad if you're ok to try saving some $.

I would try the PDR, and get a replacement glass. Might be a long wait for the replacement quarter panel, then cutting then welding on then repaint and blend.

I had the same noise two months ago on cooler weather. Booked service, and they replaced: COOLING FAN AND SHROUD SERVICE ASSEMBLY (1494179-00-B) warranty covered.

$400-$800 if not going through insurance. I had the same damage

Bring to a body shop should be a cheap $400 job

For the Model 3, these guys have them.. Tesla Model 3 Rear Brake Caliper Guide Pin Kit, 2017-2020 I wonder if Model 3 and Model Y rear brakes are the same and this will work?

Can't find the part number for the Model Y non performance rear brake slider pins and bolt on the parts site on epc.tesla.com Would be the part on the top/bottom of part 15.

Uses both, First bit will use your regen motor braking per se. But if weather is quite cold and regen is limited it will start blending in more of the regular brakes, brake pads/rotors to slow you down.

Went into the service mode then infotainment -> connectivity and my primary antenna is in red and “open” Took off the interior door panel to check the antenna connections and it’s fine. Took off the front driver side kick panel where the antenna connection goes and it’s fine. Took the...

replace the whole module that includes the 4 switches.

Same issue here. They replaced same part. Under warranty.

Same dilemma I had, bought model 3 with FSD back in 2018 with the special discount. Then bought model Y with no FSD end of Sept. Decided to keep both vehicles.

The issue with the PPF on top of the sensors is if it isn't cut out, it creates a 'bubble' since there's uneven surface level of the bumper, the circular rubber outline and the sensor. the PPF will create a sort of bubble if you know what i mean.

this is from sept

Same I got a demo vehicle, and no PDI fees. Just checked my Motor Vehicle Purchase Agreement Sheet. Ontario.

I installed 1114984-00-A on my June 2022 build Model Y and it works with the vehicle, opens my Chamberlain garage no problems.

Imagine all the folks who took delivery on Dec 14th. and then all the folks who took delivery of Dec 13th. Can't please everyone unfortunately.

My 7 seater didn't get a 3rd row carpet floor mats. No matter because I installed tuxmat model y 7 seater mats which are marvelous.

You'll be fine

same still hunting for a 7 seater for my June 2022 build.

Correct, not lubed from factory, do it before the winter, or heck do it right after delivery.

Shipping from Ukraine.. They still shipping and operating?

Just buy 3M VHB tape and cut it to your needed coverage. $5-7 bucks.

This is normal behaviour as the vehicle is applying the brake already .

If you follow the wiring, there may be some electrical tape or a small black zip tie that is keeping it close to where you currently mounted your homekit module. I would get automotive double sided tape and mount it to the front where the oem homekit bracket would go so it's closer to the...

It's no longer beta beta.

Yes compared to my Model 3, the Model Y requires more space when doing a full lock turn.

Yes, don't use those aftermarket metal ones. Not worth the trouble.

Finally, a month after I had to haggle with service to activate my self installed homelink module lol

Canadian Pricing

Get this one https://www.1975creations.com/product-page/copy-of-quick-bandit-model-3-license-plate-mount Use the coupon code drivetesla for 10% off at checkout.

You can have my front OEM mud flaps free.. I'm over by Fairview Mall, North York supercharger. DM me. Only used for 1.5 months.

looks like rust proofing hole covers. Rust proofing company drills holes through your panels. To cover it up they place these over them.

I got a set of these for my Model Y https://www.aliexpress.com/item/1005004216827841.html?spm=a2g0o.order_list.0.0.43451802z9i9O7 installed it and looks decent. I have full coverage ppf on my car so I'm fine with the smaller mud flaps. Kept scraping with the mudflaps that came with my model Y...

Yes lots of orange peel on XPEL PPF. very noticeable.

My first Model 3 back in 2018 - PPF only the full front and rocker panels. Struct a concrete pillar on the front passenger side bumper area. PPF saved the paint. Replaced the bumper portion and all was good. After 4 years I see lots of scratches around the door handle area due to ppl's...

Here’s mine. First pic shows how the door wasn't aligned with the body panels.. Second photo the body portion of the door with the nick, and when opening the door it hits the front door and causing the paint scratching.

I had the same on my Model Y 7 seater, driver side rear door not aligned, when opened it would nick the front door at the exact same sharp body line. Lucky I discovered this within 24 hrs of delivery and had the service center align the door and they performed touch up paint to fix the small...