CID-UPDATER, Gateway config

[sabaxxi]

Hello, i have one issue. Whant to configure gateway from Linux, i am connecting to cid-updater by netcat or by telnet, connection is establishing but on next command to > gwxfer i have notification about unauthorized commands, only works: status, auth, exit, install
My firmware version is 2020.8.10.1 as i know it didn't need to be rooted, also i try connecting by sudo -i, but same problem.
I don't have big linux skills but, i think it's enough,
Please share how to authanticate, or make changes in GTW, tegra board

 

[brainhouston]

i'm not too familiar with rooting in general and older software but pretty sure root was needed on all versions, it was just easier before...

 

[KyleDay]

Correct. CID-updater is only for issuing a few commands to the updater listener. You need shell access/root to invoke the gwxfer commands.

 

[sabaxxi]

Root need on every new configurqtion? One local worker make about 4-5 monthes ago configuration method like i wrote there, now i am trying same as and can't download internal.dat
Maybe i am connecting not right IP, or i need some authentication, or missing there some command?

Correct. CID-updater is only for issuing a few commands to the updater listener. You need shell access/root to invoke the gwxfer commands.

Can you explain how to? What i need to do next, after nc cid port or telnet cid port?

 

[yutian]

Previous firmware is required, such as 2020.36.11