To read the On-Board-Diagnostic data from the car using an android phone or tablet, you need to purchase an OBD reader, and the Torque Pro software.
Look here for a list of compatible hardware - Re: recommended obd2 adapter?
I recommend the Konnwei KW902 for use with Torque Pro.
Available for 16 USD here https://www.amazon.com/KW902-ELM327.../dp/B01FJGWPSO/ref=sr_1_3/154-1342145-6635569
I have had one of these for a year. I use it connecting to an android phone over bluetooth.
I added an OBD extension wire with a switch. This solves the possible problems that the KW902 has. 1/drawing power when the car is off. 2/having an insecure password.Tonsiki OBD 2 Cord 16 pin M/F Male to Female Right Angle Diagnostic Extension Cable with Power Switch to avoid battery drain
I pushed the OBD connector back out of its clip to allow room for the plastic cover to be closed. The OBD extension wire is threaded under the steering column so that the switch and adapter can sit under the navigation by the accessory ports.
Once you have an adapter and have managed to connect to it with your phone, you will have to install the specific codes for the Soul EV into Torque.
They are here - OBD-PIDs-for-HKMC-EVs/Soul EV at master · JejuSoul/OBD-PIDs-for-HKMC-EVs · GitHub
If you run into problems installing the codes or connecting with bluetooth please ask for help on the Soul EV forum
Setting up Torque to show BMS data
Look here for a list of compatible hardware - Re: recommended obd2 adapter?
I recommend the Konnwei KW902 for use with Torque Pro.
Available for 16 USD here https://www.amazon.com/KW902-ELM327.../dp/B01FJGWPSO/ref=sr_1_3/154-1342145-6635569
I have had one of these for a year. I use it connecting to an android phone over bluetooth.
I added an OBD extension wire with a switch. This solves the possible problems that the KW902 has. 1/drawing power when the car is off. 2/having an insecure password.Tonsiki OBD 2 Cord 16 pin M/F Male to Female Right Angle Diagnostic Extension Cable with Power Switch to avoid battery drain
I pushed the OBD connector back out of its clip to allow room for the plastic cover to be closed. The OBD extension wire is threaded under the steering column so that the switch and adapter can sit under the navigation by the accessory ports.
Once you have an adapter and have managed to connect to it with your phone, you will have to install the specific codes for the Soul EV into Torque.
They are here - OBD-PIDs-for-HKMC-EVs/Soul EV at master · JejuSoul/OBD-PIDs-for-HKMC-EVs · GitHub
If you run into problems installing the codes or connecting with bluetooth please ask for help on the Soul EV forum
Setting up Torque to show BMS data