power frunk install in NJ

[TMCPANDA]

anyone in Northern NJ had their power frunk installed or know anyone who can install? for Model X Raven. thanks

 

[davezforce]

I installed mine. It wasn’t too bad honestly. How handy are you with tools?

 

[TMCPANDA]

I installed mine. It wasn’t too bad honestly. How handy are you with tools?

Im ok. Just nervous about the part where the screws are hard to get to removing the button in raven models only.

 

[davezforce]

Im ok. Just nervous about the part where the screws are hard to get to removing the button in raven models only.

Yea that was actually the worst part. I wedged a little piece of wood in between to give a little more space then I took the torx bit, inserted it into a 1/4 gear wrench, put duct tape on the other side so the bit wouldn’t fall out of the wrench and used that to get the screw out of that tight space.

 

[TMCPANDA]

Yea that was actually the worst part. I wedged a little piece of wood in between to give a little more space then I took the torx bit, inserted it into a 1/4 gear wrench, put duct tape on the other side so the bit wouldn’t fall out of the wrench and used that to get the screw out of that tight space.

nice. Thanks

 

[TMCPANDA]

Yea that was actually the worst part. I wedged a little piece of wood in between to give a little more space then I took the torx bit, inserted it into a 1/4 gear wrench, put duct tape on the other side so the bit wouldn’t fall out of the wrench and used that to get the screw out of that tight space.

Was that a torx 25 bit?

 

[davezforce]

Was that a torx 25 bit?

I believe so. Either a 20 or 25.