Just got my front wrapped with Llumar PPF. The installer uses templates so didn't expect to have no visible seams. However, the seams appear to be rather wide at certain parts of the bumper and not necessarily consistent. Is this common?
Pic 1: seam (bumper to frunk) to edge just under 1/4" at top of bumper. However, the gap goes to basically flush as you move to the left side. As you move to the right side, the gap narrows, then widens, then narrows again.
Pic 2: seam on the left side showing no gap
Pic 3: seam gap under fog lights, more than 1/4" wide
Pic 4 & 5: may be hard to see, but there are two separate pieces for the top of the bumper and the bottom part of the bumper. As a result, there are gaps between the separate film pieces that are rather wide. Should there be no gaps for these types of templates or always a gap?
Pic 1: seam (bumper to frunk) to edge just under 1/4" at top of bumper. However, the gap goes to basically flush as you move to the left side. As you move to the right side, the gap narrows, then widens, then narrows again.
Pic 2: seam on the left side showing no gap
Pic 3: seam gap under fog lights, more than 1/4" wide
Pic 4 & 5: may be hard to see, but there are two separate pieces for the top of the bumper and the bottom part of the bumper. As a result, there are gaps between the separate film pieces that are rather wide. Should there be no gaps for these types of templates or always a gap?