Recent content by Eatsleepboost

Exactly why I went with the raw Hyevolt that was in stock for half the price. Raw looks good

https://secretev.com/products/secret-ev-titanium-lug-nut-super-street-v2s-tesla?variant=41688744296610

I recently inquired about them too.

New setup. Only pic so far. 20x10 all around with 285/35r20 PS4S

I tend to have bad service in the area I live so I did a reset a few miles from home and the gps worked properly about a half hour later and has been fine since for a week now. It’s like I get a bad week once a very couple months. Besides that it is perfect.

I have read through the other GPS posts and am still searching for a solution. My GPS on my 21’ Plaid will work perfectly for months then immediately after an update it does not work. It then malfunctions until the next update by showing my vehicle 100-200 feet to the left of actual location...

https://tsportline.com/blogs/tesla-aftermarket-support/the-tesla-model-s-wheel-guide

It depends what tires you run. Use the website below to figure it out. Factory diameter on the 19 and 21 inch rears are both 28.0in. The front 19 is 28.0 and the front 21in is 28.3in. If you at 28 or below use the 19 setting. If you are at 28.1 or above use the 21inch wheel setting. I have 20's...

I tried other shims. I loosened the bolts then used a 3ft pry bar between the lower control arm and the car body to get the leverage needed to pull down so the upper arm then comes away from the mounting point to create enough room to slide the shims in.

Just go to any used car dealer that has one in stock and drive it. Or possibly find one local for sale by owner and message them. Should be a few very close to you. Check autotrader

That’s the issue with Tesla not fixing the problem. Now the cars will have aftermarket parts and Tesla will blame any suspension issues and noises on the aftermarket parts.

Add me to the list.

Is the yoke and wheel on the 23 cars the same material?

Glad you got it resolved. Hopefully you don't put your poor car in chill mode anymore either. Mine has yet to see any mode besides plaid.

My car did not have this issue. I then changed the yoke to a wheel and I noticed the issue immediately. It has to do with the glue behind the trim panel or the lack there of. If you remove all of the old glue like I did when you press the directional the button sinks into an empty cavity because...