Search results

That may be the issue as I myself could stand to lose a few lbs. Probably not an issue for the general masses as my seat was comparable to other MXs and haven't seen other complaints on the boards. I have resorted to finding a balance with a slight recline but it leaves me leaning backwards...

Just an update. After some drives at night these last few days, the newly adjusted lights seem noticeably better to me in terms of height and therefore brightness as I am able to illuminate more. I was informed by SC that the lights are initially positioned so they are higher on the driver side...

I think that's right. I was told by SC that it was how the leather in the seats were currently being made and that even the black was different than the tan. For those considering ordering and have pet peeves with seat smoothness and uniformity then you should probably look at the ultra...

Got SC feedback on my issue with the lowbeam headlights being too low and not hitting high enough. Was told my lights were within spec. However due to my reported issue, they did tilt the lights up slightly within the margin of the spec. This may be a worthwhile inquiry and alternative for those...

I was wondering if anyone has had the sensation of sitting on a metal bar when the driver seat is in a more upright position - which is what I prefer. It feels like the filling is a little thin where bar across the middle of the seat is. The issue is alleviated the more you recline which is...

Just got SC technician feedback for my loose leather issue. Was told within comparable range of other MX with leather trim. Not sure if they are going to steam or not. Definitely a bit disappointing relative to leather seats from other manufacturers. Loose and uneven rather than tight and plush...

Bumping the question on the Lloyd mats and whether they are compatible with the current VINs. From the photos I have seen online they seem to have the earlier AP1 curve on the third row. Would appreciate any information. The boys and weather are destroying the OEM mats and would prefer the...

Took our 2 week old MX in today for first SC visit with about 8 issues including wind noise on driver side window. I don't think it's as severe as OP or some mentioned by others but there is a noticeable hollow whooshing sound on the driver side top left corner at freeway speeds. The sound is...

@S85D and @thimel thanks for the info. I couldn't imagine driving with AP that won't stop for you in an emergency (yes, even though it is only a driver assistance device). Based on AP1, and perhaps obviously, AP2 lane markings and car identification are still basic. The cars I do see on the...

I have had less than 50 miles with the new software. The TACC appears to be working okay for me so far without any safety issues. I agree with others that the distance feels closer (in either time and/or distance) than my 7 car length setting. I drive in stop and go downtown traffic. Constant...

FYI. Non pup. Hope it's in the right thread..

That's probably a question best out to your CPA on whether it is purchased and being put into use in 2016 per the language of the federal EV credit. I would think this has happened in prior years for the exact same reasons....anyone with historical knowledge?

Beautiful......but dangerous o_O

Still an issue on our December MX. Water pouring in on the driver side door onto car seat and floor. I made it a point via checklist and this thread to inspect seals at delivery. Seals were definitely "puffier" than some of the previous photos. There does appear to be a channel behind the front...

Still a major problem on ap2. I prefer to run my rear camera all the time and when it rains it looks like below. The bigger concern is you see the same screen while backing up in the rain (with a mini rear view mirror and slim rear hatchback window). It doesn't always feel entirely safe...

I haven't pulled out the front trunk to take a look to verify with OPs pictures. However, if the normal nonPUP filter is located in the same slot I would assume you could just replace with a HEPA filter which would function in the same way as the normal filter. Obviously not BH but potentially...

Cool. No reason to look for more problems . I plan on at least waiting for the original stock filter to be replaced before potentially purchasing. My down the road concern is if the part is ordered but requires a SC install and then they say can't install the HEPA because it's non PUP. Hope you...

Thanks. I am keeping hope alive for you guys as well. I have been trolling the site for a while and appreciate all the collective information as well as the stressful situations you guys are in now. FWIW, when I picked up I was told SC are double booking pick up appointments on the hour every...

Probably. Picked up Sunday in Burbank. MyTesla relatively accurate for me but a tad delayed. I received no automated email after order confirmation other than confirming appt and loan application. No production queue, scheduled for production, production complete and in transit, etc. Kept...

Also didn't purchase PUP with the HEPA being my only concern. Did this work out for you?

Picked up Sunday with same issues in tan leather. Was told it was normal and some cars had even more wrinkles than ours. Not as pronounced in the front seats but loose and slacky in the 2nd and 3rd row. Will bring it up at the next SC appt when the realign and replace the seal on the driver side...