Search results

Hello All, I bought a 70MAI dashcam and the hardware kit came three wires to connect to my Auxillary port in my speaker vent near windshield. Question is do I need a 4 pin extension cable to connect the three wires to the auxillary port or can I just push the three wires in the port? Here's...

Hello All, Tesla parts catalog says I need Air Suspension Strut Part 6006352-00-D - Left rear for my 2014 P85 however, I can not find the "D" version, only the "C". Does anyone know if that will work and what's the difference? Air Suspension Strut Part 6006352-00-C 6006352-00-D Thank you

I got my mechanic to contact Eibach and they agreed to send another set of springs. These springs were also making a knocking noise. They may have been defective. I am getting the new set installed this Friday. I will let you know how it goes.

Hey, need help with which part to buy for my 2014 P85 RWD I have a slow leak in my Left Rear Strut and need to replace it. There are three different part numbers on the Tesla Parts site. REAR AIR SPRING MODULE LEFT HAND - DM SS 6006352-07-B REAR AIR SPRING MODULE LEFT HAND - DM...

Thanks for the detailed write up. After some investigative work, I actually think the links are fine but the rear driver side is leaking air in the suspension. Every morning that side is lower by 0.5inches but when i get into the car, it self levels to even height. I have a service appt next...

yes, parked on level ground. I measured it on various grounds, all heights are the same as reported above.

Hello, I got the Eibach Pro Kit installed on MY LR yesterday (1.1 front - 1.4 rear) and one side is sitting lower (0.5 inches lower) than the other side. The floor to trim on driver rear is 29 inches and floor to trim on passenger rear is 29.5 inch. The passenger rear is perfect, approx a...

thanks for that... Will Tesla do a ride calibration from on my car if I have aftermarket lowering links installed?

Hello All, I have had my lowering links on my Gen1 MS for over 4 years and recently I noticed uneven ride height (lower on rear driver side). I took the car to mechanic who installed the links and they said the aftermarket links are rusted and they not remove them to adjust. He said if he tries...

Hello all, Does anyone have a link to the console wrap SVG file for the GEN 2 console? I've seen the GEN1 link floating around, haven't been able to find the Gen 2 link. Thanks

Vin is LRWYGDEEXPC005965 Version 3 or 4?

Im doing a similar setup but do not want the tire well gap to be that big.... would a 255/40/21 and 275/40/21 be better fit?

Who is running the 21" uberturbines on a long range MY stock suspension? how much of a gap is there? does it need to be lowered? should I get 255 40 21/ 275 40 21 tires to fill the gap?

Does the 8" screen have its own speaker? or do you have to connect to a portable bluetooth speaker?

eBay bumper with grill

Regarding Model Ys from China, has anyone received a VIN with Hardware 4 (HW4)....

Since the canadian model Ys are from China, has anyone received a VIN with Hardware 4 (HW4)....

Hello, I want to upgrade my front bumper in my gen1 model S, does anyone know who can get me the bumper/paint/installed in vancouver area? looking for a vendor. thanks

Hello, Wondering if anyone has wrapped the side skirts on a model S. Looking at getting the refreshed bumper and wanted to see if I could wrap the side rockers?

Hello, Tire noob here, quick question: will this setup: 245/40/21 + 275/35/21 work on my Turbines? will the front rub? will the fronts look weird being half an inch bigger then the rear (the 40 vs the 35)... Let me know guys, thanks!

Hey guys, Do you know anyone that does the front bumper conversion for the model S. I have the preface lift version, want the newer look painted and installed... I know SR auto in Richmond, BC does it but they charge up to $5k. thanks

thank you... this fixed it

Hello, I filled my frunk with too much stuff and when i went to close it, it would not close and now one of the latches are stuck and i can not open the frunk. It is in the open position as it is an inch open but i can fully open it. I have taken a photo of the latch and also a video of the...

you can go wider than 285 on the rear. I have 285's on the rear on stock 21 staggered turbines

Yes I got the powder coat removed from a paint shop that specializes in this kind of stuff. So far so good I've driven 5K kilometers

the dashboard app is ugly, they need to hire a designer will try out the tasker app and report back

Hello folks, I am looking for a Tesla Android App that includes a widget that can be placed on my homescreen so i can turn on the heat in my car... is there an app out there that does this? i have used, DASHBOARD for TESLA, and no luck.. thanks

I am in Vancouver BC/Seattle WA area.. Who can do the paint and install in this area? I prefer someone in the Seattle area. Please let me know

okay, i am removing the powder coat paint off the inside of the rims (the inside part of the rim where it sits on the brake rotor)...

no never have done that before... was never told to do that by service centre..

Hello folks, I got my rotors replaced at 12k miles by Tesla as it was covered under warranty... and 2000 miles later, i feel the pulsation again when i brake. Most likely need to replace the fronts again... my p85 only has 14k miles.. what could be the issue? how are they getting warped so...

all service reps have access to send you text messages through any computer at Tesla. So it is much much easier for them to communicate with us.

I updated the vehicle last week to 28.5 and since the update my Bluetooth phone connectivity has not been working... I will receive calls, I can answer them but no one can hear me via Bluetooth.....

interested in this... i live in Canada and USA, so shipping would be to where ever is more convenient for the shipper. thanks

just got these links installed... the rear is a little too low, i would like to have it sit a little higher.. Can i adjust the links by taking the tire off and adjusting the link? or do i have to remove the links and adjust?

just got these links installed... the rear is a little too low, i would like to have it sit a little higher.. Can i adjust the links by taking the tire off and adjusting the link? or do i have to remove the links and adjust?

Will the $39 Amazon camera be better than mine in 2014 September build with techP?

Good question....

yes, oem staggered wheels with 40mm offset. 8.5 front, 9 rear 245 front, 275 rear

which is the one from amazon? please send link...?

another q on this topic... i have a staggered setup on my p85, with 265's on the back. i am putting on 275's in the coming weeks.. would a 10mm spacer on the back make any difference in the look of the ride? Can i just put 10mm on the back and leave the front stock? - Tesla Model S 10mm...

damn, would love to get it for 78... vancouver wants over 500

another question to add... if you don't use all 4 prepurchased service agreements, can you get a refund?

having the same problem here... any thoughts?

please send me a price for the centre console..thanks

center console?

Yea not installing them. I just put in some LEDs I'm going to out these in the footwell

They are all over Amazon eBay.... Apparently they are much more powerful than just replacing the bulbs

I wish it was that easy.... when i take the bulb out, the bulb housing is in the way. i want to replace the entire housing..... see photos

Hello guys, anyone know how to remove the license plate bulb housing to snap in my new led bulbs. They come with their own housing. let me know if anyone has done it, thanks! photo of the leds i have: