I saw a Tesla themed home charger setup in the Nick Howe book, and thought it would be good to recreate in oz. Not sure if there is an oz thread on this already, but thought I would share the details.
The closest colour to the Benjamin Moore Neon Red I found in Oz was Taubmans Renegade (bunnings made me up a litre). The Adobe colour site lists it as a very close match.
I found a place in Sydney that laser cuts 3mm gloss white Perspex using a logo file I converted to autocad. The place is Online Laser cutting,
Laser Cutting Services Australia Wide and they were very quick (I assume they post Australia wide). Cost $39 plus postage for a 50cm wide name-logo. Happy to pass on the file or they can probably just rerun my job for you.
Bit of double sided tape (which pops the logo out a bit) and you have your own home service centre charge wall!
The closest colour to the Benjamin Moore Neon Red I found in Oz was Taubmans Renegade (bunnings made me up a litre). The Adobe colour site lists it as a very close match.
I found a place in Sydney that laser cuts 3mm gloss white Perspex using a logo file I converted to autocad. The place is Online Laser cutting,
Laser Cutting Services Australia Wide and they were very quick (I assume they post Australia wide). Cost $39 plus postage for a 50cm wide name-logo. Happy to pass on the file or they can probably just rerun my job for you.
Bit of double sided tape (which pops the logo out a bit) and you have your own home service centre charge wall!