I finally got an electrician to come out and install a Gen 3 Wall Connector in my Condo garage. I cannot connect it to WiFi, since it is an underground garage. I was able to connect to my M3LR and charge it to 90% at 48A, averaging ~40-41mph. However, the LEDs on my Gen 3 Wall Connector remain on when I disconnect the charger from the car. It looks like all are green, but the middle LED has a blue-ish hint to it.
I left it in my vehicle until my vehicle hit the set charge limit (90%) and the Gen 3 did not turn into the single blue light either, it remained fully on with all LEDs on.
Any ideas on how I can remedy this?
I left it in my vehicle until my vehicle hit the set charge limit (90%) and the Gen 3 did not turn into the single blue light either, it remained fully on with all LEDs on.
Any ideas on how I can remedy this?