Hi,
Bit of a lengthy post but if anyone have any superior troubleshooting.....
Installed both power frunk and power trunk from Hansshow june 2020.
Frunk V3, Trunk V4. No kick sensors.
Everything worked fine until a few weeks ago. Now frunk is giving me trouble.
Not permanently, but happens from time to time. So a little worrying.
The frunk unlatches fine, but motor doesnt engage.
When closing the frunk the latch opens but
motor does not engage. Have to push the frunk down manually.
When using the debugging cable the frunk closes fine with the frunk button, and opens fine by itself after the wait.
I’ve been troubleshotting with Hansshow for several sessions but nothing really solves the issue.
- Checked cable connections
- Checked 12V and ground connection
- Set higher open/close strength
- Reset control box
- Software update control box
- Shorting control box with screwdriver
- Calibrating struts
My suspicion is either motor / motor cable
or control box is giving me the error.
Anyone have any insight on this ?