This has possibly been discussed, but I have searched for hours and found some close but not exact setups. Has anyone ran the Bloxsport 18mm front and 25mm rear spacers on a lowered M3P? I have H&R springs to install soon, but the 25mm spacers seem like a lot on the rear, the 18mm didn’t arrive and apparently won’t until the end of the month. Just worried I may have some issues when I start putting it all together. Running the factory uberturbines on a 2022 M3P. Has anyone else ran this setup? Thanks for your time!
-
Want to remove ads? Register an account and login to see fewer ads, and become a Supporting Member to remove almost all ads.
M3P Bloxsport spacers and Lowering springs
- Thread starter Logan00757
- Start date
Lindenwood
Active Member
From what I have read, 25mm in the rear is a bit past flush at the top of the fender well with factory 20” Uberturbines and rotors, but lowering it will tuck the wheel in a hair more. It will probably around flush at the top, or a hair outside flush.
The 25mm on the rear does sit outside just a hair, which I’m not a fan of. Hoping the lowering springs pull it in a tad.
m a x i m u s
Member
I have 18mm rear on my lowered M3P with Ubers. The wheel face seems to stick out past the fender a smidge, but hard to tell with the stretched 235’s. I’ll have to reassess the spacer situation when I get 255’s.
Similar threads
