Good Morning Everyone,
I just replaced the rear drive unit for my 2013 Tesla Model S P85... the vehicle is unable to going into Service mode via MCU Software screen. Tried holding down the VIN on MCU, but the system doesn't prompt or respond. Appreciate any help you can provide. Wanted to know whether if this is something that can be addressed via Toolbox 3.0 @tesla subscription for $500/month... or If this is something that needs to go to my local service center.
I've been doing some research regarding Toolbox 2.1, but not sure if that will do the job @reflashing the vehicle to recognize the foreign (new) drive unit that I put in the car. Any insight is much appreciated.
GTW_F208
Unable to Start vehicle
(service is required)
GTW_F084
Software update required
(schedule service)
GTW_F014
Software update required
(schedule service)
BMS_u019 (old error message) to be addressed later.
I just replaced the rear drive unit for my 2013 Tesla Model S P85... the vehicle is unable to going into Service mode via MCU Software screen. Tried holding down the VIN on MCU, but the system doesn't prompt or respond. Appreciate any help you can provide. Wanted to know whether if this is something that can be addressed via Toolbox 3.0 @tesla subscription for $500/month... or If this is something that needs to go to my local service center.
I've been doing some research regarding Toolbox 2.1, but not sure if that will do the job @reflashing the vehicle to recognize the foreign (new) drive unit that I put in the car. Any insight is much appreciated.
GTW_F208
Unable to Start vehicle
(service is required)
GTW_F084
Software update required
(schedule service)
GTW_F014
Software update required
(schedule service)
BMS_u019 (old error message) to be addressed later.