So I finally had two more PWs installed and I now have a total of 4 on my 100A single phase supply.
Slight snag I’ve hit is that the installer said he can only make the PWs charge at a minimum of 16A for each.
So at “cheap o’clock” I now have a draw of 64A for the PWs (charging from mains in the winter) and 32A for the car. This is 98A (duh!) and leaves precious little to run the house and definitely not enough for the 16A immersion heater.
What I really wanted was for the PWs to charge at no more than around 10kW so about 45A in total (but still be able to discharge at the 20kW for the whole system).
Does anyone know if Tesla have the flexibility to set this configuration? Who should I contact to make this request?
Slight snag I’ve hit is that the installer said he can only make the PWs charge at a minimum of 16A for each.
So at “cheap o’clock” I now have a draw of 64A for the PWs (charging from mains in the winter) and 32A for the car. This is 98A (duh!) and leaves precious little to run the house and definitely not enough for the 16A immersion heater.
What I really wanted was for the PWs to charge at no more than around 10kW so about 45A in total (but still be able to discharge at the 20kW for the whole system).
Does anyone know if Tesla have the flexibility to set this configuration? Who should I contact to make this request?