Wall Connector (Gen 3) Possible to loosen terminal block screws?

[gl_tch]

Apologies if this is super obvious, but I just purchased a Wall Connector and upon opening the package, the screws in the terminal blocks are already partially tightened (I.e. it’s not possible to fit 2 of the 3 wires in the terminal block - I haven’t inserted the terminal screws yet)

Is there a way to loosen these so I can fit the wires in?

 

[el-guapin]

Yes. Unscrew using the supplied 4mm Hex bit.

 

[gl_tch]

Thanks @el-guapin

I’m going to pretend I didn’t ask this question…

(Stupidly assumed the casing screws were there terminal screws)