P3D-R
Closed
Which lugnuts are you using? In theory a 60 degree conical should be the same but it's very wise of you to put that "disclaimer". "Use at your own risk or count your threads."Yes, you are right, and have my apologies! This is with factory 2022 M3P rotors.
One unknown: I am not sure if number of available turns would change with the factory 21mm lug nuts.
TIP for the laymen person to count rotations, I tighten 4 out of 5 lugnuts down and torque to spec. Then that last lugnut I'll put a line on my socket and count the turns. Then continue counting the finstal rotations when torquing. I have found this to be the best method for an accurate count and hopefully not stretching threads.
Last edited: