MPP sports coil settings

[Bennny]

My perches were set at 73/16, and comp/rebound set at MPP’s recommended settings. Unladen, the front right is sitting 4mm lower than the rest.

Am I better off adjusting that coil up to level the car out, or just leaving as? I don’t particularly want a car out of level, but don’t want varying spring rates either.

 

[tm1v2]

My understanding is changing the spring perch height in the front won't change your spring rate, so long as you're using linear rate springs. Any "sport" spring should be linear.

4mm lower in one corner sounds bad to me, I'd adjust it to match. I doubt driver's weight will balance that out, not on a 4000 lbs Model 3 with firm springs. I'm no expert though!

 

[The Other Dan]

You'd be better off going to a race shop to get it cornerbalanced.

 

[tm1v2]

You'd be better off going to a race shop to get it cornerbalanced.

@The Other Dan That's true if @Bennny is tracking the car. I was assuming street use only - corner balancing would be a waste of money or time just for street driving (no matter how hard you shred your favorite twisties).