TMC is an independent, primarily volunteer organization that relies on ad revenue to cover its operating costs. Please consider whitelisting TMC on your ad blocker or making a Paypal contribution here: paypal.me/SupportTMC

Anyone in the Seattle area have rear facing seats? Need to create some templates.

Discussion in 'Northwest' started by Crusoe, Feb 11, 2016.

  1. Crusoe

    Crusoe Member

    Joined:
    Apr 13, 2012
    Messages:
    24
    I hope to do the RFS install this Sunday or Monday and need to create some carpet cut templates or get measurements primarily for the hip striker wires/latches on each wheel well. The insulation layer is pre-perforated but I haven't checked and don't think the underside of the carpet is pre-perforated. All the other cuts should be easy and have some fudge room with nice bezels to cover them up. The striker wires need to be near dead on.

    Anyone willing to meet at a coffee shop (coffee on me) in the next few days?

    Otherwise, I suppose I could go the the show room if the MS has RFS. I'm sure they'll love me crawling around back there with a measuring tape, pencil and paper. :biggrin:
     
  2. Alysashley79

    Alysashley79 Member

    Joined:
    Oct 4, 2013
    Messages:
    646
    Location:
    Seattle, WA
    We have RFS in our car. Where exactly are you located? I'm over on the east side with my s
     
  3. Crusoe

    Crusoe Member

    Joined:
    Apr 13, 2012
    Messages:
    24
    It's ok, I did the install last weekend. The hip striker wire holes were not to hard to line up, everything else was easy to cut without any measuring.
    Thanks nonetheless.

     

Share This Page