I helped my friend install a TeslaOffer frunk in her 2019 X today. Overall, the install was quite simple. I followed TeslaOffer's YouTube video exactly and everything seemed perfect. When I went to test the closing, it would not pull the frunk lid all the way down leaving a 1 inch gap. After over an hour of adjusting, tuning, etc., I still could not get the frunk to latch without helping it by pushing down on the frunk lid. At this point I was pretty frustrated and had doubts about the kit. I was about to give up and then my friend came to have a look. He spent some time fiddling as well and finally he noted that the hook part of the frunk lid was installed poorly by the factory. It was way off to the passenger side so we unbolted it and centered it (moving it towards driver's side) and bolted it all back together. Voila! It worked perfectly. I was doubting the kit but it was actually a poorly installed hook from Tesla. The TeslaOffer kit performed exactly as it should have. Below is a pic of the latch hook before adjusting it and arrows showing direction I moved it.
If you decide to install one of these, make sure the hook is not so off center like this. Could save you a lot of time.
If you decide to install one of these, make sure the hook is not so off center like this. Could save you a lot of time.