Anyone remember this reply that I wrote about back in Mid-June?
Today I was down at Min Plastics, (just off Dillingham near King). I discussed with them this plate
and doing it again. I gave them my pattern and discussed material and cost.
Bottom line: Min Plastics will make/sell you this safety inspection backing plate for your license plate for $ 18.00 + tax.
It will be a about 1/8-3/16th thick, and clear plastic like. I don't know the material, but clear is cheapest,
and I think will blend better with all cars. They are also going to drill holes where a tag would overlay the plate.
It will be a little smaller so as to fit behind and be covered by the license tag in case you use a frame that surrounds the tag and hooks around the edges of the tag.
My beta versions of this cost $ $ 20.00 for material and $ 15.00 to be cut. Min sells it car-ready for $ 18.00
Min Plastics
921 Kaamahu Place
Honolulu, 96819
Questions?
Sweet! Thanks Akikiki!