I've had the kit for over 6 weeks but it's been too hot or I haven't had time to start until today. First I cleaned and clay barred all the trim. Then I got started with driver side T1.
I completely botched it. I was partially in the sun at 65 degrees and thought it would still work. I ended up over stretching the piece because I kept having to pull it back up to fix alignment. Unfortunately I had to trash the driver T1 piece.
I almost decided to just give up and not even attempt the rest. But I waited till I could get the car completely in the shade and moved on to driver T2. I went much slower being careful not too overstretch. It went on fairly well.
Moved on to T3. I used the method mentioned earlier in the thread and started at the back corner point. It also went on fairly well. I was on a roll.
On to the long T4. I'm guessing I was way too careful not to overstretch the T4 because I ended up with about a quarter inch gap between where T4 and T3 are supposed to meet.
As a stop gap, I cut a piece off the T1 piece that I had to trash and filled in the gap. I applied a little heat from the heat gun to try to smooth it out. I guess it could be worse.
View attachment 465394 View attachment 465395 View attachment 465395 View attachment 465395
The passenger side door trim install went without a hitch after learning from all of my mistakes on the driver side.
I also installed the camera housing pieces. These took some time with quite a bit of stretching and manipulation with shots of heat here and there. They turned out pretty well.
I'm saving the door handles and mirrors for another day.
@Kenriko How can I go about getting a replacement for drivers side T1 in satin black? I'm currently driving around with all the door trim deleted except drivers T1.