Just installed my Spoiler, and wanted to give a run down to anyone attemping the same!
I purchased the Matt-Black Spoiler from
Yikun Car Accessories Store on Ali-Express - Total came to $65/£52 with Shipping
Ordered on the 23rd of April and the Spoiler arrived on the 11th of May. So around 3 weeks delivery with the cheapest delivery option.
The package was 'Average' very similar to the other photo in this thread, however it was wrapped in Bubble Wrap and arrived with no damage. Included was the Spoiler with 3M Tape applied, and some 'Adhesion Promoter' Wipes (Which were Alchol Wipes)
I applied the Spoiler using the included tape, after deep cleaning the car and application area; however within 24 hours it was already lifting off the car at both ends. I also was unable to get the rear/underside of the spoiler to attach correctly to the car as the top side was so darn sticky it gripped the boot of the car hard and fast.
I then ordered a bottle of 3M Prime 94 10ML & 3M VHB 5952 10mm x 3 Meters.
Taking the spoiler off was worringly easy, however removing the existing tape was the biggest pain, I found the best method to be using a cotton bud and rolling up and off the tape, leaving the least residue. And a quick clean up of any left over gunk with some Isoproal Alchol
I re applied the tape and used the extra 20cm to reinforce the middle section of the spoiler.
On application, I only removed the tape from the bottom section of the spoiler, and left a little tuft of tape from the side corner for the tape on the top. This allowed me to get the spoiler in the right position, and to make sure that the bottom stuck!
5 Minutes of clamping it to the car, I removed the tape from the top, being careful not to tear it and then got my bottle of Primer 94 (which effectivly seems to be Super-Glue). I dribbled it under the top of the spoiler around the edges where it's known to lift, and then clamped it hard for another 5 minutes.
Initial opinions, the Primer 94 seems to do a hell of a job in promoting the adhesion of the tape; I'll report back if there's any issues over time.
TLDR: Don't use the Supplied tape. Grab a bottle of Primer 94 & Remove the bottom tape first, before doing the top.
Oh, and here's the final product;