I have two 200 amp services into my home. So when they installed my 3 powerwalls, they split them up and put 2 powerwalls on Gateway A and 1 powerwall on Gateway B. I have since noticed that my power consumption is greater on Gateway B.
Question 1:
I would like to swap my powerwall configs so that Gateway B has 2 powerwalls and Gateway A has just 1 powerwall. Can the control wires and power wires/breakers just be swapped from one gateway to the other or are they "married" to each gateway?
Question 2:
If I leave the current configuration alone and then add a fourth powerwall (so that I have 2 powerwalls on each gateway), is there some special configuration only available to installers? or is it something I can do without a "certified" installer?
Thanks in advance
Question 1:
I would like to swap my powerwall configs so that Gateway B has 2 powerwalls and Gateway A has just 1 powerwall. Can the control wires and power wires/breakers just be swapped from one gateway to the other or are they "married" to each gateway?
Question 2:
If I leave the current configuration alone and then add a fourth powerwall (so that I have 2 powerwalls on each gateway), is there some special configuration only available to installers? or is it something I can do without a "certified" installer?
Thanks in advance