hi everyone - my UMC gen 1 will give me the red light of death (3 blinks red). Tried holding down reset button for 10 seconds and watched device reset. Still get red. Plugged into 10-30 dryer. Before this it worked fine for 4 months
When I plug it into 120v it works fine (both 15 and 20 amp)
I only use the official Tesla adapters with all these outlets. I had an electrician come out and he said the 10-30 outlet was fine. He then asked for gas money and left (wtf?).
If anyone is local to Rancho Penasquitos in San Diego can you please stop by with your known working UMC gen1 and try my 10-30 plug? You can just use my tesla UMC gen1 10-30 adapter.
Also I’m accepting other ideas too. Already tried:
- cycle breaker
- check for loose breaker / loose wires
- check voltage: 240v
- hold reset button on UMC for 10 seconds
Thanks!
Edit: I should add the issue is intermittent. Sometimes it works.
Edit2: as a thank you I’ll let you charge for free and my wife
When I plug it into 120v it works fine (both 15 and 20 amp)
I only use the official Tesla adapters with all these outlets. I had an electrician come out and he said the 10-30 outlet was fine. He then asked for gas money and left (wtf?).
If anyone is local to Rancho Penasquitos in San Diego can you please stop by with your known working UMC gen1 and try my 10-30 plug? You can just use my tesla UMC gen1 10-30 adapter.
Also I’m accepting other ideas too. Already tried:
- cycle breaker
- check for loose breaker / loose wires
- check voltage: 240v
- hold reset button on UMC for 10 seconds
Thanks!
Edit: I should add the issue is intermittent. Sometimes it works.
Edit2: as a thank you I’ll let you charge for free and my wife
Last edited: