I'm done with the console footwell and the lights under the seats.
I used these lights after splitting them and soldered an individual connector to each of them (did this to the two kits I had).
for the console footwell, I snapped the trim out then disconnected the light, removed the two screws that held the light assembly in place, then using vhb tape I placed one of the lights above. I installed a submodule in the console as there is the usb hub that gets power with a connector similar to the charging tray. please note that this one has different layout for the pins (yellow +~16v, brown ground). This means that you will keep the original light assembly as a spare as is left out of the picture.
Moving to the driver under seat lights.
Using a T45 I remove the 4 (very very tight) bolts that hold the seat in its place so I could juggle it to work under it. I installed one controller under the seat
and piggy back to the connector in the video red for +~16v and black for ground. Again I disconnected the two ambient lights. I used two of the lights in the picture above and placed them over the existing light assemblies.
For the left hand side under seat I followed the same process, however the color coding under the seat its purple +~16v and black ground.
This required a lot of effort as the screws are very very tight.
The only viable lights left might be the door puddle lights, but I am unsure if I will attempt them.