P3dStealth
Active Member
I installed my frunk today. Overall it's a good setup. The only thing I think needs improvement is the inline fuse. It should be waterproof and I am wondering if it really should be a 25amp fuse. I wrapped it in electrical tape really good. They did good on the rest of the kit. All other connectors had rubber seals.
I had a problem where it was not retracting. Turns out a pin in one of the connectors was not locked in and when I connected it the pin just pushed out the back. Easy fix but it took me a while to figure it out. If you have a problem check your connectors.
I found a glitch. If you leave the hood open long enough the car will go to sleep and a while after that the module will go to sleep. This is good. The glitch is when you wake the car If you go to close the hood it will only open even though it is still open. You won't be able to close it. You will have to hold the module button to reset it again. They need a firmware update to fix this.
I had a problem where it was not retracting. Turns out a pin in one of the connectors was not locked in and when I connected it the pin just pushed out the back. Easy fix but it took me a while to figure it out. If you have a problem check your connectors.
I found a glitch. If you leave the hood open long enough the car will go to sleep and a while after that the module will go to sleep. This is good. The glitch is when you wake the car If you go to close the hood it will only open even though it is still open. You won't be able to close it. You will have to hold the module button to reset it again. They need a firmware update to fix this.
Last edited: