V21.31.1

[Bitslizer]

Just got upgraded last night.

2 observed change compared to 21.31.0

1) remote CT now show up under system page. In this case it's my standalone 3.8 Tesla inverter

2) the auto setup powerwall button is back? I think it was gone the last version.

 

[BGbreeder]

What does the "auto setup" button do?

Curious...

 

[Bitslizer]

What does the "auto setup" button do?

Curious...

It just add the powerwall to the gateway during install

 

[kairojya]

It seems that they also fixed the Powerwall charging briefly from the grid over and over again once their state of energy drops to the reserve level. I’m not sure if this has been discussed here. There was some discussion on Reddit about it, my post with screenshots here:

https://www.reddit.com/r/Powerwall/comments/pb030t/_/haldygg

 

[kb1ibt]

It seems that they also fixed the Powerwall charging briefly from the grid over and over again once their state of energy drops to the reserve level. I’m not sure if this has been discussed here. There was some discussion on Reddit about it, my post with screenshots here:

that was mentioned over in the 21.31.0 thread. Specifically the 100W trickle charge.