I am curious about one thing. The shroud is a one piece "circle" without a break, isn't it? So, in order to take it off and replace it with your larger shroud for the system with extension brackets, I assume you would have to completely remove the display, unplugging any connecting wires in the process, then slide the old shroud off, bolt the extension brackets on to the display, slide the new shroud on, reattach the wires, bolt the extension brackets on to the existing frame attachment point, then snap the cover back onto the new shroud. There must be enough extra give in the connecting wires to extend far enough to reach the new display location, extended. Is that the process?
I assume also that there are only 2 brackets holding the display in place. Is that display currently actually held in place with just 2 points, one screw in each? Some of this I know I could find out by popping things apart myself, not quite that brave yet on a car I have only had for a week.
I assume also that there are only 2 brackets holding the display in place. Is that display currently actually held in place with just 2 points, one screw in each? Some of this I know I could find out by popping things apart myself, not quite that brave yet on a car I have only had for a week.