Finally started modding my Tesla - Monoblocks

[Indpowr]

I have custom wheels 3 piece on my Vette and Camaro as well as few other wheels on my other rides. So the Tesla felt left out so, we went with the below setup. The monoblocks should hold the horsepower well.

So we added
1 piece forged wheels
100% American made
21x9 = 26lbs
21x10 =28lbs
Finish is Kandy black translucent powder coat.

I think the outcome was nice.the last picture was prior to the change.

 

[Doanster1]

Looks good! Question... assume you're on air and have lowering links installed?

 

[Indpowr]

Oem
Just sas

 

[mcbarnet007]

looks amazing!

 

[Akikiki]

Wow, is that a halo on top in one of the pictures?

 

[Doanster1]

Oem
Just sas

Wow! That's very low for stock SAS. I'm happy then. No need for lowering links when my CPO arrives, unless of course, Gen 1 Air Suspension is different than SAS.

 

[Indpowr]

Halo? Lost on that lol

My car is a.2015 so not sure.about Gen sas

 

[P85DBeast]

Wow! That's very low for stock SAS. I'm happy then. No need for lowering links when my CPO arrives, unless of course, Gen 1 Air Suspension is different than SAS.

Im pretty sure all SAS is the same on all car's.

 

[Doanster1]

Im pretty sure all SAS is the same on all car's.

Good to know. @Indpowr 's first pic makes it look like the wheel is quite "tucked", hence my question. May just be the angle. Either way, I'm happy that SAS will allow it to go fairly low. I just don't like huge wheel gap.

 

[Indpowr]

100% agree as i like slammed cars lol
My vette has almost a 4" drop haha

I think its the angle throwing it off some

 

[Ludalicious]

See any difference in range?

 

[mcbarnet007]

Low setting on SAS looks pretty good but the normal height is just a tad lower than coil suspension.