I'm about to buy a 3D printer, one of many reasons (or rationalizations for a new toy) is to print thingies for my MS. I've got an awesome UMC holder @uberEV1 printed (thanks!), and I have seen coin holder print on this forum, as well as discussion of various other possible parts. I plan to print:
a) 1/2" thick brake pedal pad to clip over (and thereby raise) current pedal... like many others, I've experienced the dangerous unintentional "coast" that comes if you clip a bit of the accelerator whilst braking. I'm not waiting for Tesla to address, though I think they will have to eventually - hopefully before something bad happens to somebody.
b) additional shelving unit to fit forward in my center trough (below existing shelf)
c) storage tray to provide 2 levels of storage in the hole @ driver's side rear in trunk. I currently find this area useless for storage, because items I put there sink down and often disappear into well.
d) prints other people dream up and make available on forum (that's my next thread if it is not already there by the time I get the printer)
e) whatever else comes to mind
I've done some web research and MakerGear M2 looks really, really good to me. Reviews are great, US company (matters to me), good print size. But, before I order, it occurred to me that I'd probably get useful input if I post a thread, so please have at it!
a) 1/2" thick brake pedal pad to clip over (and thereby raise) current pedal... like many others, I've experienced the dangerous unintentional "coast" that comes if you clip a bit of the accelerator whilst braking. I'm not waiting for Tesla to address, though I think they will have to eventually - hopefully before something bad happens to somebody.
b) additional shelving unit to fit forward in my center trough (below existing shelf)
c) storage tray to provide 2 levels of storage in the hole @ driver's side rear in trunk. I currently find this area useless for storage, because items I put there sink down and often disappear into well.
d) prints other people dream up and make available on forum (that's my next thread if it is not already there by the time I get the printer)
e) whatever else comes to mind
I've done some web research and MakerGear M2 looks really, really good to me. Reviews are great, US company (matters to me), good print size. But, before I order, it occurred to me that I'd probably get useful input if I post a thread, so please have at it!