Finally had a few moments to put some on. Going to do it in 3 sessions I think. Did the driver side and door handles, saving the mirrors for last. It might be the cooler temps, just above 60 today, but, I had some stretching to do on all the pieces, 1/2-1 inch. Not a problem once I knew it was consistent based on length. I have a couple redos I will do after the winter, my first door handle has a small crease, the camera shows a flash of chrome when looking down on it, hard to stretch the T3 piece properly, have some over hang in the inside corner (I might start on the V corner next time), but, all in all, it went well. I am a professional "nitpicker", so don't that this as a negative. I am looking forward to seeing how this holds up to the elements here in MI this winter, then I will replace anything that doesn't pass muster in the spring. I really like the matrix black. Great kit Kenriko!