WhipperDipper
Member
First results were a no go.
My Leaf recognized the J1772 and initiated charging, but after 5 minutes, stopped (based on 3 blue lights on dash). When pressing the latch handle on J1772, I can hear an audible click as it seems the pilot Is correctly landed.
When plugging this setup into a Model 3 with adapter, everything starts to initiate, but eventually errors out with a red T and message on screen ‘Unable to charge-charge station not powered’. Via the Model 3 screen, it shows 0/32A and 1V when plugged in.
Thinking I may have a bad J1772 cable (unlikely), I swapped the Tesla cable back into the HPWC to use on Model 3 only. Same results. Seems that I have a bad HPWC. Looking further into diag on this, but any help appreciated.
There is a red flashing LED on the board, near the connection for L1/L2 to cable. This flashes steady while powered, regardless of any actions. Wondering if this is normal, or indication of error. As far as the cover goes, only green lights. It passes test mode when initially installing. For reference, I have a 14-50 cable wired into input. 14-50 plug is good, and measured 240V at fuses.
My Leaf recognized the J1772 and initiated charging, but after 5 minutes, stopped (based on 3 blue lights on dash). When pressing the latch handle on J1772, I can hear an audible click as it seems the pilot Is correctly landed.
When plugging this setup into a Model 3 with adapter, everything starts to initiate, but eventually errors out with a red T and message on screen ‘Unable to charge-charge station not powered’. Via the Model 3 screen, it shows 0/32A and 1V when plugged in.
Thinking I may have a bad J1772 cable (unlikely), I swapped the Tesla cable back into the HPWC to use on Model 3 only. Same results. Seems that I have a bad HPWC. Looking further into diag on this, but any help appreciated.
There is a red flashing LED on the board, near the connection for L1/L2 to cable. This flashes steady while powered, regardless of any actions. Wondering if this is normal, or indication of error. As far as the cover goes, only green lights. It passes test mode when initially installing. For reference, I have a 14-50 cable wired into input. 14-50 plug is good, and measured 240V at fuses.