I have 2020 model with 2020.20.12
If im trailing a car below my TACC speed, and the left lane is clear, I want to signal left and have the car speed up to overtake (while manually controlling steering)
This is from the manual:
But whether I hold down the stalk at half-press or full-press, the car either stays at the same speed or slows down. If im going at 100kph limited by the car ahead with TACC set at 130kph, and the left lane is indicated and its clear, the car simply wont accelerate to 130kph..... sorta annoying
If im trailing a car below my TACC speed, and the left lane is clear, I want to signal left and have the car speed up to overtake (while manually controlling steering)
This is from the manual:
Overtake Acceleration
When following a vehicle with Traffic-Aware
Cruise Control active, briefly engaging the
turn signal (to indicate a move into the
passing lane) accelerates Model 3 towards the
vehicle ahead. By momentarily holding the
turn signal lever up or down, you can quickly
accelerate up to your set speed without
having to press the accelerator pedal. The turn
signal causes acceleration only when all of the
following conditions are met:
• Traffic-Aware Cruise Control is operating
and detects a vehicle in front of you.
• No obstacles or vehicles are detected in
the target lane.
• Model 3 is traveling below the set speed,
but over 72 km/h.
When following a vehicle with Traffic-Aware
Cruise Control active, briefly engaging the
turn signal (to indicate a move into the
passing lane) accelerates Model 3 towards the
vehicle ahead. By momentarily holding the
turn signal lever up or down, you can quickly
accelerate up to your set speed without
having to press the accelerator pedal. The turn
signal causes acceleration only when all of the
following conditions are met:
• Traffic-Aware Cruise Control is operating
and detects a vehicle in front of you.
• No obstacles or vehicles are detected in
the target lane.
• Model 3 is traveling below the set speed,
but over 72 km/h.
But whether I hold down the stalk at half-press or full-press, the car either stays at the same speed or slows down. If im going at 100kph limited by the car ahead with TACC set at 130kph, and the left lane is indicated and its clear, the car simply wont accelerate to 130kph..... sorta annoying