Themitigating
Member
I had this issue with two different sets of lights from aliexpress, it bugged me really bad. So I gave up.
I spoke with the store and he sent me a diagram and said changes had to be made. I had my friend translate but it still not obvious. Since the drivers side does work I wonder if just jumping one cable over the passenger side might work.
So the light has the following functions
1. Steady when Headlights on
2. Scrolling when Turn signal for that side on
3. Flashing when Headlights on AND (Brake pedal depressed OR regen?) AND speed > X
Since there are four wires, one being the ground, then shouldn't one wire send the required signal?
Below is the diagram he sent me for the changes partially translated by my friend. I'm going to investigate how the light works by sending power to each wire.
So far -
red 12v - flash 3 times then steady
yellow 12 - scroll once then steady
blue 12v - startup motion then steady
an important note is I'm applying 12v steady, I assume for the yellow wire and red wire it's intermittent to create the effect
Last edited: