Looks great. I love the red brakes and the lighter sunroof. Since I don't use FSD, I am ok without HW4, and all the rest of the stuff is on my Nov build 2023, such as the matrix headlights, new taillights, fog lights, bigger rear screen, tilt center screen, etc. And now I have a round wheel.
But I thought I was going to lose my mind because your panel gaps looked so perfect in the other video. It's really not a Model S Refresh without wonky panel gaps somewhere on the car, and mine were hideous front and rear, but at least the doors and glass were ok.
I can see now that your hatch is wonky, so welcome to the official Refresh club! It can be adjusted to look better.
Your trunk is shifted a little to the left, which is super easy to adjust by moving the striker a tad to the right.
View attachment 925544
The right side at the top is a little high compared to the left side at the top, and that's a bear to fix, but I put up some DIY info on how to adjust the height at the top. My SC refused to touch it because they have to remove and replace the back glass with a new one to do the job, but I found out how to do it without removing the glass.
View attachment 925545View attachment 925554
This is a weird one, but it looks like they somehow cause the right rear quarter panel to stick out at the bottom near the Plaid badge. Not sure how you fix that. May have to bend the metal panel back in. Compare left to right.
View attachment 925546 View attachment 925547
The right side is a little high on the bottom side compared to the left side that is a little low. That's easy to fix by adjusting the bump stops, along with the height of the striker for the latch.
View attachment 925548View attachment 925549
Yours is not terrible, but because mine was so hideously bad, and the SC refused to fix it, I had to become an expert in rear decklid adjustment on my own. It's impossible to get a perfect fit because the panels are no longer shaped correctly, but it can be tweaked to be unnoticeable.