Those door pieces are supposed to be that way meaning you don't want to roll/wrap the bottom edge of the doors because:
1. There is not enough flat surface for the film to stay firmly on the back side of the bottom door edges. because of this if you try to wrap the edges under the doors, they will lift very soon and it will be very ugly and you will have to trim it.
2. when you stop the film before the edge, you need that 1 mm before the actual edge. that 1 mm from the actual edge/end of the door is where the flat surface stops, so that the film will not lift.
3. Same goes for the door handle cuts.
1. There is not enough flat surface for the film to stay firmly on the back side of the bottom door edges. because of this if you try to wrap the edges under the doors, they will lift very soon and it will be very ugly and you will have to trim it.
2. when you stop the film before the edge, you need that 1 mm before the actual edge. that 1 mm from the actual edge/end of the door is where the flat surface stops, so that the film will not lift.
3. Same goes for the door handle cuts.