Finished! The install task was 3 out 5 if you like playing with Legos and you have the right tools. I'm going at this blind just by videos and what people have said on the thread. I completed the project in about 2.5 to 3 hrs. The biggest part for me was the lower C pillar and lower seat cover thing.
I started with the left driver side. Figured this had the charger and 12v attachment so it took a little more finesse. What everyone said about the lower C pillar is true it's a pain, but once it's removed the access to the seat belt bolt is super easy (socket extension is needed 6in min. 10in is good) Note make sure you remember the orientation of the seat belt, it's keyed so it can only go one way but make sure you tuck it under the carpet then place the plastic over the carpet or else it makes a rubbing noise added to your other creaking noise in the car.
Install tips:
Watch the video of the guy tinting the roof, and read the install for the CCS adapter to remove the lower C pillar.
1. Lower C pillar in the front by the seats will have 2 metal clips with locator pins. These are a pain to remove. Tug enough around them and you can pull the one on top. The lower one is very hard, just place your hand close to the pin and hulk it and the sucker will pop out. The rest is held on by the upper c pillar.
2. Trick for upper c pillar separation to prevent the clips from falling. Slide you hand in between the separation and when you get close to a clip push in the top c pillar and swiftly pull on the bottom c pillar.
3. Once the lower C pillar is free you can remove the seat belt bolt. The bolt does have Loctite. You will feel the resistance when unbolting. Make sure you add Loctite again before installing.
4. Take a pic of the seatbelt placement so you remember how to reinstall.
5. Removing the upper c pillar use swift tugs to free the plastic clips-, I took pictures of each pin location. same for the passenger side.
6. Where the c pillar meets the roof liner by the trunk hold the liner and tug the c pillar.
7. Wiggle you way out of the rear door roof liner.
8. Freedom!! well almost remove the seatbelt guide, dont break it you need it.
Remember it's always easier uninstalling
Picture time. I took pictures of where the plastic white pin connectors will mount to the frame. So when you install the new c pillar you can place your palm at these locations and pop them in.
I made a video of the passenger side install, I should have it up shortly.
Thanks for the help everyone!