ruffieuxh
Member
Hi I did two last week and had the same problem. When I toke the whole image, it didn´t work. My solution was to take each partion and run fsck on partion 3 and 4 to remove any logical fault in the filesystem. Then it worked.
About soldering: do not use to much flus - it is a large chip
Thanks jrhansen.
When you say "take each partion and run fsck on partion 3 and 4", what do you mean exactly? Did you extract (dd) each partition seperately or did you dd the entire image, mounted the image and then run fsck on P3 and P4?
Best regards
Heinz